Saw Guide Pipe Cutting 1/2" id. to 6.0" id

Saw Guides for Pipe Cutting

1/2" id. - 6.0" id. Capacity Available

SG 0.50P - 1/2" id. Pipe to SG 6.00P - 6.0" id. Pipe

Nickel Chrome Plated Hardened Steel

Easy to Use with Porta Band, Sawzall or Hack Saws

Note: Not for use with thin wall tube.

Easy Setup	The wing nut design allows the guide to be locked onto the tube without the use of external devices. Just wrap the guide around the pipe and tighten the wing nut for the cutting operation.
Roll pin	A hardened solid pin is inserted into the guide just below the finished cut line that will stop the saw blade from cutting into the guide. If the saw blade comes in contact with the pin, the pin will spin and not damage the saw blade or the guide.
Nickel Plated	The hardened steel saw guide is nickel plated to insure non-contamination of the pipe or tube.
Double Slot	(Patent Pending) Double slot guide has two slots. Narrow for a portaband and a wider one for a sawzall blade. This is to ensure that the tolerances are kept tighter on the cut on the ½" thru 3.5" sizes. The 4" and 6" have single slots.
Rounding	The design of the guides also allows it to be used as a rounding clamp in certain tube applications.
Sizes	Sizes for pipe are available from ½" to 6"

Write a Review

Saw Guide PIPE Cutting 1/2" id. to 6.0" id